Stäng denna sökruta.

Xdeep Hydros DIR

Dubbelflaska? Inget får gå fel? DIR? Då är denna väst nått för dig. Kör du dubbelpaket och kanske i vrak, djupt, gruva eller helt enkelt vill ha en väst med så lite grejer som det bara går? Välj stål eller aluminum platta och storlek på blåsan.

Vill du designa BCDn själv med färger namn etc, gå in på https://tuneup.xdeep.eu/

Skicka sedan koden till mig.


4,820.00 kr5,388.00 kr

Xdeep Hydros DIR

Artikelnummer N/A Kategori Etikett


Xdeep Hydros DIR 40/50

Designed to exceed the expectations of demanding tec divers

Familiar in looks, innovative and functional in use

Whilst the HYDROS system might be easily recognisable, every element has been addressed to ensure an enhanced diving experience. Building all of the elements around a carefully calculated geometry, we significantly improved stability in the water.

We eliminated the ‘dead zones’ that trap air, increasing drag or affecting buoyancy. We ensured you have great access to your valves through a careful top wing design. Holding flat and expert trim in this wing is made easy, whether you are a new technical diver or have hundreds of decompression dives and want the security and comfort of the best system possible.

Trim and Stability to meet the most critical eye

Learning how to hold good trim and a stable position in the water is often the hardest skill for a new technical diver. For an experienced technical diver they want their equipment to help, not be something they have to compensate for. The HYDROS was designed so that the buoyancy in the wing perfectly matches the centre of gravity of the gas in your twinset.

Irrespective of the inflation level of the wing, or the remaining cylinder pressure, the system trim will not change during the dive.

Valve Shutdowns – faster and safer

The last thing you want between you and your valves is a flap of wing that slows down your response to a problem. Shutdowns and valve management have been improved by reducing the volume of the wing in the valve area, and through the area where you want to route your hoses.

Its easier to configure a clean and tidy hose routing, leaving your valves clear and accessible.

Reduced drag but the same buoyancy

Smaller contour wings have less drag and a lower risk of entanglement. In classic twinset BCD designs if you reduce the contour of the wing, then you lose overall buoyancy. Not in the HYDROS.

By minimizing the dead zone in the HYDROS from the central part of the bladder, we have reduced the overall wing contour and kept all the buoyancy you need. A bit of lateral thinking!

Comfortable and high up at the surface

It is a challenge to design a wing that holds you in perfectly flat trim underwater, yet holds you upright and high at the surface. Most designs want to push your face back underwater. In the HYDROS the design ensures that the majority of the wing and therefore buoyancy is kept beneath the surface.

Even loaded with two full stages and gear for a deep technical dive, HYDROS will hold you high and comfortable out of the waves.

Ytterligare information

Vikt N/A
Storlek på blåsa

40, 50


Stål, Aluminium


Det finns inga recensioner än.

Endast inloggade kunder som har köpt denna produkt får lämna en recension.

This website uses cookies. By continuing to use this site, you accept our use of cookies.